How To Repair Drywall On Outside Corner

How to Repair Corners of Drywall

Comments: 0
Favorites: 0
Completions: ane

How to Repair Corners of Drywall

Time Required

12 - 16 hours

Introduction

Even the most mindful homeowner, or renter, can cease up dinging a corner in their home. Vacuuming, or kids playing, and all of sudden there is fleck in the the corner of the wall. Countless amounts of money go to repairs, or lost security deposits, that hands could have been averted if the person did the repair themselves. With a few items, that can exist institute at any big department shop pretty cheap, a homeowner could salve themselves a bunch of money. This guide volition make the process effortless, and give a step by stride process that will be easy to follow along. In the end, giving confidence to the user to mayhap endeavour other home repairs without a second thought.

four inch Drywall pocketknife
6 inch Drywall Pocketknife
Phillips #2 Screwdriver
Pencil
Tin can Snips
Utility Pocketknife
80 Grit Sandpaper
120 Grit Sandpaper
Record Measure

Measure top and bottom of damaged section.

Mensurate top and lesser of damaged section.
When replacing a corner bead, you must mensurate at least 1.v inches from the corner.
Use a directly edge between the the top and bottom and depict a straight-line connecting the marker.
You tin even use the putty knife if the damaged section is not too long.
Mark with a pencil, or cut lightly with utility knife.
Use caution when using the utility knife as the blade is very sharp and may crusade an injury.

Using your putty knife, dig out of the spackle inside your marking.

Using your putty pocketknife, dig out of the spackle within your marking.
Yous need to get downwards to the metal, or vinyl corner drywall bead.
Utilize caution to not dig too deep.

Unscrew screws in the section of bead that yous are going to remove.
If it is a vinyl corner bead, so intermission taped underside with corner of putty knife carefully.
Cutting the metal corner bead with tin snips.
If Vinyl, then employ your utility knife.
Measure new corner bead and cut.
Place new corner bead on corner and fasten in place using screws or tape.

Apply joint compound with a four inch putty knife.
The more compound the ameliorate. It will compress while drying.
Do not worry about getting corners the perfect.
Dry for 12 hours.

Sand area with eighty grit sandpaper.
Wipe downward with clammy cloth, sponge, or paper towel.
Be careful to not moisture down the patch with besides much water. Only minimum amount of dampness needed to wipe abroad sanding dust.
Apply thinner coat of joint compound with a half-dozen, or viii inch putty pocketknife.
Pay attending to put pressure level on the outside border.
Let dry for ii hours.